facsBridge™ f2eRouter - Software and Infrastructure Requirements

1. Windows Server 2012, 2008 or 2003.

2. Windows Fax Service installed and configured.

3. A telephony infrastructure (e.g. PABX) that supports direct inward dialing (DID), and a fax modem that reports called number as Routing Information. Open Windows Fax and Scan, go into Inbox, navigate to View -> Add/Remove columns and add Routing Information. The routing information should contain called number. Sometimes a modem initialization Hayes AT command is required to enable called number reporting (ANI/DNIS reporting), consult your modem documentation.

Download facsBridge™ f2eRouter

The evaluation version becomes a full version on entering a registration key (a license needs to be purchased, no separate product download is required).

Please note, facsBridge™ T37FSP and facsBridge4Exchange™ include facsBridge™ f2eRouter. There is no need in the stand-alone f2eRouter if T37FSP or facsBridge4Exchange are already installed.

THE PROGRAM IS PROVIDED ON AN "AS IS" BASIS, WITHOUT WARRANTY OF ANY KIND, EITHER EXPRESSED OR IMPLIED, INCLUDING, BUT NOT LIMITED TO, THE IMPLIED WARRANTIES OF MERCHANTABILITY AND FITNESS FOR A PARTICULAR PURPOSE. THE ENTIRE RISK AS TO THE QUALITY AND PERFORMANCE OF THE PROGRAM IS WITH YOU. SHOULD THE PROGRAM PROVE DEFECTIVE, YOU ASSUME THE COST OF ALL NECESSARY SERVICING, REPAIR OR CORRECTION.

Please read Licence Agreement before downloading.

Download facsBridge™ f2eRouter facsBridge™ f2eRouter version 3.6.2

History and release notes
May 2014 - v.3.6.2 - test email is fixed.
January 2014 - v.3.5.3 - application event log is rationalised.
May 2013 - v.3.5.1 - f2eRouter is now available as a stand-alone product.

To install and configure f2eRouter refer to f2eRouter documentation.